Inching Mode; Removing The Stripping Leftovers; Counter Reading Menu; Switching Off The Machine - Weidmuller Power Stripper 6.0 Manual De Instrucciones Original

Operating the machine

6.5 Inching mode

A work cycle can be performed slowly in inching mode.
► Keep the display pressed while you turn the machine on.
The hand symbol flashes.
► Press the display to move the mechanics to the corre-
sponding stage in the work cycle.
► Keep the display pressed for 3 seconds to exit inching
mode.
The machine switches to the production menu.

6.6 Removing the stripping leftovers

► Press the display once briefly.
The hand symbol appears.
► Briefly press the display again.
An empty cycle is performed.
The machine switches to the production menu.

6.7 Counter reading menu

► Keep the display pressed for 3 seconds.
The current counter readings are displayed.
3. Counter
4 Total counter
0 Day counter
199 996 Service counter
► Keep the display pressed for 3 seconds.
The day number is set to zero.
► Briefly press the display.
The machine switches to the production menu.
When a wire is inserted and the machine is started, it auto-
matically switches to the production menu again.
28

6.8 Switching off the machine

► Switch the machine off.
The display goes out.
When you finish the work, you should empty the
waste container and put it back into the machine
(see section 7.4).
2562260000/01/10.2017