D - Configuration; Quick Configuration Assistant; Réseau [Network]; Camera Config Page - THOMSON 512323 Manual De Instrucciones

Plug and Play 16 channel colour
network Video recorder

1 - QUICK CONFIGURATION ASSISTANT

When you start up your device for the first time the
configuration assistant will run, which will enable you
to set up your device with just a few clicks.
If you would like to deactivate the assistant the next
time you reboot your device, tick the 'Désactiver
l'assistant au prochain reboot' [Deactivate the
assistant at next reboot] box at any time.
Click 'Suivant' [Next] to start your device's quick
configuration process.
1.1 - rÉsEau (NEtWork) pagE
Here you can configure your recorder's network
settings. It is recommended to maintain the default
settings: "DHCP" ticked, "UPNP" activated. Click
'Suivant' [Next] to continue.

d - CONFigurATiON

1.2 - camEra coNfig pagE

All cameras connected to the same network as the
recorder appear here. To speed up detection, click
the "Attribution auto IP/Caméras' [Auto assign
IP/Cameras] button. Click 'Suivant' [Next] to
continue.
(Please refer to paragraph 2.9 "Manual
camera pairing" for more details.)

1.3 - programmE pagE

Here you can set the week's recordings for each of
the cameras, in half-hour increments, for the whole
week.
• The diagram on the screen shows the
behaviour chosen for the whole week. The scale
at the top of the diagram shows the time (hour)
of the chosen day (0 to 24). The letters on the
left indicate the corresponding day of the week:
"S" = Sunday, "M" = Monday, "T" = Tuesday, "W"
= Wednesday, "T" = Thursday, "F" = Friday, "S" =
Saturday. By default constant recording is
activated for the whole week: each half hour is
coloured green.
EN
9