Complete The Installation - Kohler K-505 Guia De Instalacion

Install the
finished wall
material
1/16" (2mm)
above the
enameled
surface
Apply silicone
sealant to the
joint between
the bath and
the finished wall

5. Complete the Installation

If your bath requires grip rails, install them now according to the packed instructions.
Cover the framing with water-resistant wall material.
Seal the joints between the bath rim edges and the water-resistant wall material with silicone
sealant. Tape and mud the water-resistant wall material.
Install the finished wall material so it is 1/16" (2mm) above the enameled surface. Seal the joints
between the bath rim and the finished wall with silicone sealant.
Install the faucet trim according to the faucet manufacturer's instructions.
Clean-Up
When cleaning up after installation, do not use abrasive cleaners, as they may scratch and dull the bath
surface. Use warm water and a liquid, non-abrasive detergent to clean the surface.
CAUTION: Risk of product damage. Do not allow cleaners containing petroleum distillates to remain
in contact with the surface for long periods of time.
Remove stubborn stains, paint, or tar with turpentine or paint thinner. Remove plaster by scraping with a
wood edge. Do not use metal scrapers, wire brushes, or other metal tools. You can use a powder-type
detergent on a damp cloth to provide mild abrasive action to any residual plaster.
Kohler Co.
Water-
Resistant
Wall Material
Framing
Bath
5 1023720-2-A