Complete The Installation - Kohler K-1313 Guia De Instalacion

7. Complete the Installation

Install the apron according to the packed instructions.
Carefully remove the protective tape from the bath rim.
Apply a bead of silicone sealant to the nailing-in flange.
Install water-resistant wall material a maximum of 1/4" (6 mm) above the bath deck.
Seal the joints between the bath rim edges and the water-resistant wall material with silicone
sealant. Tape and mud the water-resistant wall material.
Install the finished wall. Seal the joints between the bath rim and the finished wall with silicone
sealant. RTV (Room Temperature Vulcanizing) sealant is recommended.
Install the faucet trim according to the faucet manufacturer's instructions.
Clean-Up
When cleaning up after installation, do not use abrasive cleaners, as they may scratch and dull the bath
surface. Use warm water and a liquid, non-abrasive detergent to clean the surface.
CAUTION: Risk of product damage. Do not allow cleaners containing petroleum distillates to remain
in contact with the surface for long periods of time.
Remove stubborn stains, paint, or tar with turpentine or paint thinner. Remove plaster by scraping with a
wood edge. Do not use metal scrapers, wire brushes, or other metal tools. You can use a powder-type
detergent on a damp cloth to provide mild abrasive action to any residual plaster.
1023717-2-B
All manuals and user guides at all-guides.com
Water-Resistant
Wall Material
Bath
Framing
Finished
Wall
Apply silicone
sealant to the
joint between the
bath and the
finished wall
6 Kohler Co.