Factory Settings; Types Of Alarm - DAB MCE-22/C Instrucciones De Instalación Y Mantenimiento

Page 11.0
10.

FACTORY SETTINGS

Parameter
Regulating mode
Hs (Differential Pressure Set-point)
Fs (Frequency Set-point)
Tmax
Operating mode
Set-point reduction percentage
Twin operating mode
Pump start control
11.

TYPES OF ALARM

Alarm Code
e0 - e16; e21
e17 - e19
e20
e22 - e30
e31
e32 - e35
e37
e38
e39 - e40
e42
e43; e44; e45; e54
e46
Table 6: List of Alarms
On page 11.0 you can set the system status in ON, OFF or controlled by a remote
signal EXT (digital input I1).
If ON is selected the pump is always on.
If OFF is selected the pump is always off.
If EXT is selected, reading of the status of digital input I1 is enabled. When input I1
is energised the system goes ON and the pump is started (on the Home Page the
messages "EXT" and "ON" appear alternately at bottom right); when input I1 is not
energised the system goes OFF and the pump goes off (on the Home Page the
messages "EXT" and "OFF" appear alternately at bottom right).
For the connection of the inputs see par. 5.5.1
Alarm Symbol
ENGLISH
= Regulation with constant differential pressure
50% of the max. pump head (see inverter sensitive
parameters set in factory)
90% of the pump rated frequency
50 ºC
auto
50 %
= Alternate every 24h
EXT (from remote signal on input I1).
Alarm Description
Internal Error
Short Circuit
Voltage Error
Voltage Error
Protocol Error
Excess temperature
Low voltage
High voltage
Excess current
Dry operation
Pressure Sensor
Pump Disconnected
58
Value