Transport And Storage; Mounting Of The Fixed-Value Controller - BARBERI P27.T Manual Para El Usuario

14
6.

Transport and storage

Prove carefully, if there are damages at the packaging or at the controller.
Only transport the controller in the original packaging.
The controller may be damaged, even if it falls down of a low height.
Avoid hits or shocks and extreme temperatures during transport and storage
(below 0 °C, above + 50 °C).
The controller may only be storaged in the original packaging and in dry surrounding areas.
7.

Mounting of the fixed-value controller

Adjust the mixer manually in central position (45°) of the scale. If there is an adjustment grip, remove it from the
mixer axis. Screw in the fixing bolt (torsion locking device) and put the motor coupling on the mixer axis. The
needle of the motor coupling has to point to the central position of the mixer.
The colour scale for the position indicator can be adjusted to the direction of the mixer (flow right = VR, flow left
= VL). Pull off the adjustment knob from the controller, remove the position indicator and put it in again in the
desired position. Push on the adjustment knob again. The position is predefined by raster toothing. Put the
fixed-value controller on the coupling. The position indicator has to face upwards. Fix the controller on the
mixer axis with the central screw in the adjustment knob. The fixing bolt has to latch in the accordant space on
the backside of the controller housing. Switch the gear to ‚manual' (
90° (on the scale from 0 to 10). For electrical operation the controller has to be switched to ‚automatic' (
again.
The running direction of the actuator can be adjusted via the internal DIP-switch No. 1 (see chapter 9.3)
Schemas see following page!
Operating and commissioning manual - EN
). Check, if the coupling can be turned
)