Hotpoint Ariston KTI 6114 Instrucciones Para La Instalación Y Uso página 11

When the hob is plugged in for the first time, an audio signal
sounds after a few seconds. You can then turn on the hob.
Power on
To turn on th power, hold your finger on the button
Heating zone controls
Each heating zone is controlled by one of the selection
buttons, whose design reflects the configuration of the
heating zones themselves
8. 8.
8. 8.
and by two power level buttons :
To turn on a heating zone and increase its power level,
select the desired heating zone. Then adjust the power
level, which is displayed in steps from 0 to 9.
To set a heating zone to maximum power immediately,
press briefly on the "-" button. The heating zone is turned
on at 100% power.
To turn off the heating zone, press on the "+" and "-"
buttons at the same time. The power level is immediately
set back to 0 and the heating zone is turned off.
or press the "-" button. The heating zone's power level
descends gradually until it is turned off.
To turn off the entire hob simultaneously, press the
button ; The entire hob is turned off. Be sure to unlock
the hob before turning it off.
4 or 3 residual heat indicator lights
Even after a heating zone is turned off, its residual heat
indicator "H" lights stays on to show that the corresponding
heating zone is still hot (temperature over 60°C). These
indicator lights warn you of the risk of injury by burning.
Detection of cooking vessels
Each induction heating zone is equipped with a cooking
vessel detector. Heat is generated only when a suitable
cooking vessel is placed on the heating zone.
When the power indicator
- the cooking vessel is made of incompatible, non-
ferromagnetic material,
- the cooking vessel is too small,
- the cooking vessel has been removed.
Choose cooking vessels that match the diameters of the
heating zones. Small pots should be used with small
heating zones, etc.
How to use the different controls
.
8. 8.
8.
flashes, this can mean:
How to lock the controls
When the hob is on, it is possible to lock the controls so
that the settings cannot be changed inavertently (due to
cleaning, children playing, etc).
Hold your finger over the button
next to the
To modify the power level of stop cooking, all your
need to do is press the button
light goes off.
You must the reselect the desired heating zone to
reactivate the settings.
Safety features
If an object (pan, lid, etc) is left on the control zone for
more than 10 seconds or a button in the controls zone is
pressed for too long, an audio signal is triggered.
• To stop the audio signal, remove the object causing the
interruption. The hob is now turned off.
• To reactivate the controls, follow the procedure for turning
on the hob.
KTI 6114 & 6014 models only
To speed up the temperature rise of the rear right
heating zone, press the Booster key
power indicator will display P. The Booster function stops
automatically after 4 minutes. While the Booster is on, the
maximum power of the front right heating zone is limited
to 600 W.
KTI 6114 model only
It is possible to programme the cooking time of a (any)
heating zone for a maximum duration of 99 minutes. Select
the power level and then proceed as follows:
• Select the
8.8.
function
• With the
duration
• Confirm the operation by pressing the programming key
again.
The timer starts counting down immediately. An audio
signal sounds at the end of the cooking time and the
heating zone switches off.
11
the indicator light
button goes
again, the indicator
p
, and the
key to access the programming
keys, set the required cooking
on.