Personal Safety; Tool Use And Care - Enarco TORNADO E-BATT Manual De Instrucciones

If you detect any electrical damage to the charger, contact the technical service of ENARCO or an
authorized dealer.
DO NOT EXPOSE the charger to rain or wet conditions. Keep it clean and dry.
CHARGE only batteries 104490 / 5RSK0001 from ENARCO.
DO NOT OVERLOAD the charger of the battery. Disconnect the charger from the mains once the
light of the LED indicator turns into green colour to avoid damaging the battery.
NEVER subject the charger of the battery to IMPACTS.
DO NOT EXPOSE battery charger to sources of heat or fire.
Charging TEMPERATURE of the battery is between 0ºC and 45ºC.
DO NOT EXPOSE the battery charger to rain or wet conditions. Keep it clean and dry.
CLEAN carefully the contacts of the charger with a clean and dry cloth in case they get dirty.
The charger must be STORED in a dry place and away from the direct sunlight.
NEVER use the charger over flammable materials or in explosive environments.
NEVER use the charger down the direct sunlight neither at temperatures below 0ºC.
NEVER force the plug of the charger, it must fit smoothly in the power point.
NEVER use any plug adaptor.
KEEP the charger away from children.
KEEP the power cable and the charging cable clean and avoid them to contact with oils or corrosive
substances.
KEEP the power cable and the charging cable away from cutting edges.
NEVER use the cable neither the plug to carry the charger.

3.5 PERSONAL SAFETY

STAY ALERT, watch what you are doing and use common sense when operating a power tool.
DO NOT USE THE TOOL while tired or under the influence of drugs, alcohol, or medication.
DRESS properly.
DO NOT WEAR loose clothing or jewellery.
CONTAIN long hair.
KEEP your hair, clothing, and gloves away from moving parts. Loose clothes, jewellery, or long hair
can be caught in moving parts.
AVOID accidental starting.
BE SURE switch is off before plugging in. Carrying tools with your finger on the switch or plugging in
tools that have the switch on invites accidents.
REMOVE adjusting keys before turning the tool on.
DO NOT overreach.
Always KEEP properly fed and balanced.
USE safety equipment.
ALWAYS WEAR eye protection. Dust mask, non-skid safety shoes, hard hat, or hearing protection
must be used for appropriate conditions.

3.6 TOOL USE AND CARE

USE clamps or other practical way to secure and support the work piece to a stable platform.
DO NOT FORCE the tool.
USE the correct tool for your application. The correct tool will do the work in a better and safer way.
DO NOT USE the tool if the switch does not turn it on neither off.
DISCONNECT the battery before making any adjustments, changing accessories, or storing the tool.
STORE idle tools out of reach of children and other untrained persons.
MAINTAIN tool with care.
CHECK for misalignment or binding of moving parts, breakage of parts, and any other condition that
may affect the tools operation. If damaged, contact the technical service or an authorized dealer before
using again.
USE only accessories that are recommended by the manufacturer for your model.
"TORNADO E-BATT" BATTERY VIBRATING SCREED
en
7