Storage; Transportation; Locating Malfunctions - Enarco TORNADO E-BATT Manual De Instrucciones

6.2 MAINTENANCE
1.-
2.-
3.-
4.-
5.-
6.-
7.-
8.-
Re-screw the nuts and bolts daily.

6.3 STORAGE

1.-
2.-
3.-
4.-
5.-
6.-

6.4 TRANSPORTATION

1.-
2.-
3.-
6.5 WASTE DISPOSAL
1.-
2.-
3.-
7.

LOCATING MALFUNCTIONS

PROBLEM
The motor does not
work
The screed does not
vibrate
"TORNADO E-BATT" BATTERY VIBRATING SCREED
The works on the electric parts must be done by a specialist.
During the maintenance, make sure that the device is disconnected from the power source.
Always use original parts by every maintenance operation.
The bearings of the motor do not need a periodic maintenance.
Inspect the charger and switch connections every 100 hours.
Clean periodically the housing of the motor to prevent an overheating.
The safety fittings must be checked after every maintenance.
Every 12 months or more frequently the screed must be sent to an authorized workshop for
service according to the intensity of the usage.
Always store the screed clean, in dry and protected areas, when it is not used for a long time.
To prevent corrosion from occurring, store the batteries in a place with relative humidity less
than 80%.
Store batteries at a distance greater than 2.5m from other dangerous substances.
Store batteries separate from metal products.
Store the batteries at a temperature between 5 and 25ºC.
If the batteries are stored for a long time, they must be in a dry place at the specified temperature
and they must be fully charged every 3 months.
During transportation, the screed must be ensured against slipping, overturning and bumps.
Batteries are governed by a specific standard for packaging and transport, with restrictions in
some cases, especially in cases of air transport. Respect these rules depending on the means
of transport used.
To pack and transport the charger, do not fold the cables, roll them up without forcing them.
Disposal of the battery must be done through your dealer, the manufacturer or at the battery
waste management points designated for this purpose. The seller and the manufacturer are
obliged to collect the battery and to arrange its proper recycling or disposal.
NEVER dispose of the battery as if it were household waste, it may cause serious damage to
the environment
Proceed to recycle the rest of the electrical and mechanical components according to the current
regulations for each type of waste in your country.
Check the battery charge level.
Check that cables and switch are in good condition.
Operate the switch very quickly 2-3 times in a row
not start check other causes.
Defective motor
Check the joints between the vibrating group and the blade.
Check that the motor has not been manipulated. If the load on the
eccentrics is manipulated, there may be no vibration.
CAUSE/SOLUTION
. If it does
en
9