Service; Specific Safety Rules; Operation And Maintenance; Getting Started - Enarco TORNADO E-BATT Manual De Instrucciones

4.

SERVICE

Tool service MUST BE PERFORMED only by qualified repair staff.
When servicing a tool, USE only identical replacement parts.
FOLLOW the instructions in the Maintenance section of this manual.
5.

SPECIFIC SAFETY RULES

1.-
2.-
3.-
4.-
5.-
6.-
7.-
8.-
9.-
10.- The acoustic power level of these machines could be a risk for health (see characteristics sheet,
11.- The hand-arm vibration level of these machines could be a risk for health (see characteristics
en
FURTHERMORE, THE OPERATOR IS COMPELLED TO RESPECT ADDITIONAL REGULATIONS ENFORCED
6.

OPERATION AND MAINTENANCE

6.1 GETTING STARTED

1.-
2.-
3.-
4.-
5.-
6.-
7.-
8.-
9.-
8
For the proper use of this device, please assure that the operator has been correctly informed
of the content of this manual before using it.
This screed must be used only under the applications for which it has been designed and
according to these safety instructions.
Do not touch any part of the vibrating group when the motor is running.
Do not work in an area exposed to flammable liquids or gases.
Do not allow inexperienced or not trained personnel to use the screed alone.
Always keep the vibrating screed clean and dry.
Please secure all the threads and bolts before working.
Do not stop the screed until the concrete mass is fully vibrated.
Do not work with the screed if any type of malfunction, even small, has been observed.
point 2.2). Proper protective equipment must be used.
sheet, point 2.2). The screed must always be handled using isolated gloves and all the
necessary safety equipment. Besides, the user must rest each hour of effective work.
The rubber parts used for isolating from vibration must be maintained in perfect shape. In case
of damage, they must be replaced immediately.
Before starting work, the correct operation of all handling and safety devices must be checked.
Turn off the motor switch located on the handle before starting.
Inspect the good condition of the cables.
Check that all the screws are well tightened.
Check the battery charge status.
Turn on the motor. If the battery is fully charged, operate the switch very quickly 2-3 times in
a row. The battery has an overcharge protection system that sometimes kicks in when the
battery is fully charged.
Carry out the vibration of the floor by pulling the screed by its handles, which are isolated from
vibration.
After the work is finished, clean the remains of fresh concrete adhering to the screed and to the
blade with water.
When a defect or a malfunction has been detected, endangering the use of this machine or not,
stop the work and make the correspondent maintenance to avoid any danger or bigger damage.
"TORNADO E-BATT" BATTERY VIBRATING SCREED