Cleaning And Maintenance - American Standard AquaWash Ambient 5900A05G Instrucciones De Instalación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1
DO NOT USE AGGRESSIVE CHEMICALS:
for example: hydrogen chloride, paint thinner, benzene,
abrasive cloth or
paper, polishing
agent, fragrance,
insecticide, etc.
Painting thinner
Insecticide
Abrasive
paper
3
If you start to notice that the
flow of water is low when using
the bidet seat it may be time
for the filter to be cleaned out.
Especially with new home
construction or newly
renovated plumbing there are
a lot of sediments in the water.
You will need to remove the
connection hose and clean out
the filter as needed.
5
The nozzles can be removed if needed for cleaning.
First turn off the water supply to the bidet seat.
As per figure A, pull out the tube and remove the old nozzle by pulling out straight, as shown.
As per figure B, insert the new nozzle into the tube along the corresponding slot.
6
The incoming water pressure is regulated by a regulator
insert. This can be removed and replaced.
First turn off the water supply and disconnect the connection hose.
Rotate the lever to the on position, pull out the regulator from the
inlet tube with needle-nose pliers.
Press the new regulator into the inlet tube.
Then rotate the lever back to non-working position.
Regulator

CLEANING AND MAINTENANCE

Connection
hose
Filter
A
2
You will need to clean the wands when they get build up
of residue and calcium. You can pull the wands out with
your finger and then with a soft bristle toothbrush, brush
the nozzle head.
4
You can remove
the bidet seat by
pressing the release
button on the right
side of the bidet seat
and sliding the seat
forward as shown.
This enables you to
be able to clean more
thoroughly around the
toilet. Make sure to
disconnect the
connection hose
before you do this.
7
If anything shall leak, retighten the connection and use teflon
tape if needed. If water leaks from the two ends of the water
hose, retighten the nuts to avoid water leaking
WARNING
DO NOT OVERTIGHTEN
AS IT WILL DAMAGE
THE CONNECTION.
HAND TIGHTENING IS
RECOMMENDED.
- 5 -
A
B
B
760217-100

Publicidad

Tabla de contenido
loading

Tabla de contenido