Attaching The Fan Blades - HAMPTON BAY 873 964 Manual Del Propietário

Finishing the Fan
Installation
1. Remove the two screws on two diagonal
sides from the top of the mounting plate and
loosen the other two screws (Figure 8).
2. Align the two key slots on the top of the
motor housing with the two screws on the
mounting plate, push the motor housing
up and turn it clockwise to lock in place,
tighten the two screws.
3. Install the two screws that were removed
in step 1 into the remaining two holes and
tighten firmly four screws.
Loosen But Do Not Remove
Remove
6.
Attaching the
Fan Blades
NOTE: Your fan blade are reversible. Select
the blade side finish which best accentuates
your decor.
1. Attach blade to blade bracket using the
screws supplied (Figure 9). Please note that
the rubber washers are pre-attached to the
blade bracket. Start a screw into the bracket.
Repeat for the two remaining screws.
2. Tighten each screw securely.
3. Fasten the blade assembly to the motor by
inserting the alignment posts into the slot
on the bottom of the motor and tightening
the motor screws. Please note that the mo-
tor screws are pre-attached into the blade
brackets (Figure 10).
4. Repeat steps 1-3 for the remaining blades.
Screws
Blade
Figure 8
Blade
Blade Bracket
Blade Balancing
All blades are grouped by weight. Because nat-
ural woods vary in density, the fan may wobble
even though the blades are weight matched.
The following procedure should correct most
fan wobble. Check after each step.
1. Check that all blade screws are secure.
2. Most fan wobble problems are caused when
blade levels are unequal. Check this level by
selecting a point on the ceiling above the tip
of one of the blades. Measure from a point
on the center of each blade to the point on
the ceiling. Measure this distance as shown
Figure 9
Blade Bracket
Alignment Post
Screws
Figure 10