Axis Q60 Serie Manual Del Usuario página 17

1. Install the selected bracket according to the instructions supplied with the bracket. If
drilling is required, make sure to use drill bits, screws and plugs that are appropriate for
the material.
2. Secure the camera using the supplied safety wire.
3. Route the network cable and a grounding wire through the holes in the mounting
bracket. Make sure the grounding wire is as short as possible to make the current path
as short as possible.
4. Loosen the grounding screw and remove the washer and cable shoe.
1
Network connector – RJ45 Push-pull Connector (IP66)
2 Network connector and network connector shield
3
Ground screw T20
4
Washer
5
Cable shoe
5. Attach the grounding wire (torque 1.5 to 2 Nm) to the cable shoe using cable shoe pliers.
6. Put the cable shoe and washer back in their original positions and tighten the screw
(torque 0.5 Nm). Make sure the cable shoe is in contact with the grounding surface.
7. Connect supplied RJ45 Push-pull Connector (IP66) to the network cable according to
the instructions supplied with the connector. For information how to assemble an
IP66–rated RJ45 connector, see page 20 .
AXIS Q60 Series
5
17
1