Blitz HydroLift S3 2 - 6.2 Instrucciones De Uso página 143

HydroLift
Inspection log book HydroLift
First safety check before commissioning
Only by an expert
Carry out the following test steps.
Tick where appropriate.
Gradual safety check
Quick Reference Guide
Type plate
Warning signs
Function raise / lower
Condition of load liftings wheel fork
Function procedure of the lifting cylinder
Condition of welds
General condition of the lifting system
Condition of aggregates
State of control
Condition of control panel
Check supporting parts of lifting system
(deformation, cracks)
Condition of cylinder
Checking the screw torques
Function of the safety devices
Condition of covers
Hydraulic system tight
Filling level of hydraulic tank
Condition of the hydraulic lines
Condition of the electric cables
Function test with load
Safety check performed
Date: .....................................................
Company: .............................................
Expert (name, address)
................................................................
......................................................................................................................................
Signature operator
Defects remedied on..................................
......................................................................................................................................
Signature operator
140
Defect
OK Missing
  
  
  
  
  
  
  
  
  
  
  
  
  
  
  
  
  
  
  
  
  
Result
Further operation questionable, inspection required
Further operation possible, get rid of defects
Further operation without concern, lifting system without

defect
Signature expert
For a check-up, use a separate form!
Signature expert
Please keep completed form in
the inspection log book (annex)!
Type designation .....................................
Serial number:...........................................
Verify Comment























126746