Mount And Wire Thermostat - Honeywell Prestige SD Guía De Instalación Del Sistema

1

Mount and wire thermostat

Pull wiring through hole in wallplate and install as shown below.
Drywall: 3/16" hole
Plaster: 7/32" hole
Wiring
Strip 1/4" insulation and connect wires to screw terminals as shown below
(see wiring guides on following pages).
Factory-installed jumper
Wiring must comply with local electrical codes.
Français : voir la page 17 • Español: vea la página 33
Wall anchor
3
Mounting screw
System wiring