Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Low Backguard Installation (HDZBS301)
Notice:
There are two types of Dual Fuel Slide-In-Ranges; one with
a louver cover at the back of the range and one without the
louver cover. See the following procedures to determine
which model of range that you have and which procedure
to follow.
Procedure for a Dual Fuel
Slide-In-Range with louver
cover (see Figure 1)
Tools Needed
•
Torx T20 screwdriver
•
gloves
Preparation
9 IMPORTANT!
Can you slide the range out enough to have access to the
rear and side screws of the rear louver cover and trim?
•
If you can slide the range out, continue with the
procedure.
•
If you cannot slide the range out, contact a qualified
service technician to disconnect the gas or electrical
connections that prevent the range from being pulled
out before proceeding.
•
Read the Tip Over Warning in the Safety section of this
manual. Be aware of this hazard when the range has
been pulled out of the anti-tip bracket for this
installation.
Procedure
1. Confirm that the range is cool enough to be handled on
all surfaces.
2. Slide the range out enough to access the rear louver
cover mounting screws. See Figure 1: Rear louver
cover screw locations.
3. If your range does not have a louver cover (see
Figure 1), go to the procedure starting on page 5.
4. Remove the four screws holding the rear louver cover
(see Figure 1). Save these screws to reattach the
louver cover.
9001062516 Rev A
Figure 1: Rear louver cover screw locations
5. Lift the louver cover out of the slots holding it in place
(see Figure 2). Note the slot locations for later.
6. Remove the cooktop grates.
7. Remove the screws holding the trim (five screws on the
back and one screw on each end)(see Figured 2).
Save these screws for installation of the Low
Backguard.
Figure 2: Trim screw locations (louver cover removed)
8. Rotate the trim forward, slide slightly to the front, and
lift it off.
English 3
Publicidad
Capítulos
Tabla de contenido
