Preparation; Before You Begin; Tools And Parts Needed; Parts Included - Bosch HEI80 Instrucciones De Instalación

Ocultar thumbs Ver también para HEI80:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Preparation

Before You Begin

Tools and Parts Needed

40 or 50 Amp power supply cord kit (depending on
local code).
Note: Not necessary for Canadian installations, cord is
preinstalled at factory.
Measuring Tape
Phillips Head Screwdriver
1-1/4" Wrench
Pencil
T-20 Torx Screwdriver
Screws (2) and Anchors (2) for Anti-Tip Bracket (Style
will vary depending on mounting surface)
Level
Drill and Drill Bit (3/16" masonry bit for concrete
screws)
Soapy Water
Safety Gloves and Goggles
Tape (Optional)
Cloth or Cardboard (Optional - to Protect Floor)

Parts Included

Anti-Tip Bracket
2 wood screws
2 anchorless concrete screws
Foam Tape
Terminal Lugs (For Use With Hard Wire Installations)
Note: Terminal lugs not necessary for Canadian
installations.
Additional Parts Needed for Hard-Wired
Installations
Flexible conduit
Torque wrench
Note: Power supply cord kit is not necessary for hard-wired
installations.
Remove Packaging
Remove all packaging from the appliance. This includes
external (box, tape, foam) and internal (cardboard,
packaged literature and accessories).

Installation Checklist

Please refer to the pages following for complete installation
instructions. Use this checklist to verify that you have
completed each step of the installation process. This can
help you avoid common mistakes.
___ 1. Before installing the range, be sure to verify the
cabinet dimensions are correct for your unit and
the required electrical connections are present.
___ 2. Refer to the installation manual for content
regarding Safety, Cabinet Dimensions, Remove
Packaging, Electrical Installation, Testing the
Installation and Customer Service.
___ 3. (Optional) Remove the oven door to reduce the
unit weight and to provide access to handhold for
lifting.
___ 4. Move the range unit into place in front of the
installation opening, leaving the bottom packaging
on the unit to avoid damaging flooring.
___ 5. Plug the range into a properly configured
receptacle.
___ 6. Protect the flooring from damage, then slide the
unit all the way into place, making sure to route the
power cord correctly.
___ 7. Reinstall the oven door removed in step 3 above.
___ 8. Consult the complete installation instructions and
follow the remainder of the procedures listed,
including performing an operation test.
English 4

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Heip0Hiip0

Tabla de contenido