Ethernet Connection - Zyxel P-335U Guia De Inicio Rapido

STEP 3:
The wizard attempts to detect which WAN connection type you are using.
If the wizard does not detect a connection type, you must select ONE from the drop-down list box. Check with your
ISP to make sure you use the correct type:
1 Ethernet
2 PPPoE
3 PPTP.
Note: If you were given Internet access settings, enter them in the following fields. Otherwise leave the
default settings and just click Next.

Ethernet Connection

A Select Ethernet as your WAN connection type.
B Select Get automatically from your ISP if your ISP did not assign you a fixed IP address. Skip to C.
Or
Select Use fixed IP address provided by your ISP to give the P-335U a fixed, unique IP address. Go to B1.
B1 If you select Use fixed IP address provided by your ISP, enter a WAN IP address, WAN IP Subnet Mask
and the neighboring device's IP address given by your ISP.
If you were given DNS server settings, enter them in the fields. Otherwise leave the default settings and
just click Next.
C Select Factory Default to use the factory assigned default MAC address.
D Select the check box to have the P-335U apply bandwidth management to traffic going out through the P-
335U's WAN, LAN or WLAN port according to the traffic type.
E Click Apply to save your changes. The OTIST in Progress screen appears if you enable OTIST in the
previous wizard screen. Wait for the P-335U to finish transferring OTIST settings.
WAN
ENGLISH
11