Set Up The Dual-Band Wireless A+G Notebook Adapter - Cisco Systems LINKSYS WPC55AG Guía De Instalación Rápida

Set up the Dual-Band Wireless A+G
1
Notebook Adapter
IMPORTANT: You must run the
Setup Wizard before inserting the
Adapter into your notebook
computer.
A
Insert the Setup Wizard CD-
ROM into your CD-ROM drive.
The Setup Wizard should run
automatically, and the
Welcome screen should
appear. If it does not, click the
Start button and choose Run.
In the field that appears, enter
D:\setup.exe (if "D" is the letter
of your CD-ROM drive).
B
To install the Adapter, click the
Install button on the Welcome
screen.
C
After reading the License
Agreement, click Next to
accept the agreement
D
Choose a network type. Select
5GHz or 2.4GHz if you will
connect to 802.11a, 802.11g,
and/or 802.11b networks.
Select 5GHz only if you will
connect only to 802.11a
networks. Select 2.4GHz only if
you will connect only to
802.11g and/or 802.11b
networks. Then click Next.
E
Choose a wireless network
mode. Click the Infrastructure
Mode radio button if you want
your wireless computers to
network with computers on
your wired network using a
wireless access point. Click the
2
B
C
D
E