Publicidad
Idiomas disponibles
Idiomas disponibles
RESISTANCE CONTROL / EMERGENCY BRAKE
The resistance lever is located in front of the handlebars and provides 11 levels of pedaling resistance. To increase the
resistance, push the tension control lever towards the ground. To decrease the resistance, push the lever upwards.
IMPORTANT:
• To stop the flywheel while pedaling, push down hard on the lever.
• The flywheel should quickly come to a complete stop.
• Make sure your shoes are fixed into the toe clip or pedal straps.
• Apply full resistance load when the bike is not in use to prevent injuries from moving drive gear components.
WARNING
The indoor cycle does not have a free moving flywheel; the pedals will continue to move together with the
flywheel until the flywheel stops. Reducing speed in a controlled manner is required. To stop the flywheel
immediately, push down the yellow emergency brake lever. Always pedal in a controlled manner and adjust
your desired cadence according to your own abilities. Push the yellow lever down = emergency stop.
The indoor cycle uses a fixed flywheel that builds momentum and will keep the pedals turning even after
the user stops pedaling or if the user's feet slip off. DO NOT ATTEMPT TO REMOVE YOUR FEET FROM THE
PEDALS OR DISMOUNT THE MACHINE UNTIL BOTH THE PEDALS AND THE FLYWHEEL HAVE COMPLETELY
STOPPED. Failure to follow these instructions may lead to loss of control and the potential for serious injury.
BATTERY REPLACEMENT
If you are not getting workout readings while using the optional console or a third party app, you may need to change
the battery (AA).
AA
9
Publicidad
