To Remove Accessories; To Operate The Speed Control - Kitchen Aid KHM620 Instrucciones Y Recetas

How To Use the Hand Mixer
4. Insert the accessory with a collar (B)
into the larger opening (B) of the
hand mixer. Line up the flanges on the
accessory with the slots in the opening
and push in until it locks into place.
A

To Operate the Speed Control

WARNING
Injury Hazard
Unplug mixer before touching
beaters.
Failure to do so can result in
broken bones, cuts or bruises.
1. Make certain the Speed Control is
in the "Off" position by sliding it
backward as far as possible. "OFF/O"
will be visible on the speed control
pad when the switch is in the "Off"
position.
2. Plug the hand mixer into an electrical
outlet.
5. Insert the accessory without a collar
(A) into the smaller opening (A) of the
hand mixer. Line up the flanges on the
accessory with the slots in the opening
and push in until it locks into place.

To Remove Accessories

1. Make sure the Speed Control is in the
"Off" position.
2. Unplug the hand mixer from the
electrical outlet.
3. Press the Ejector Button (C) to release
B
the accessories from the hand mixer,
then remove them.
3. Always start mixing at the lowest speed
by sliding the Speed Control forward
to the first position mark, which is
Speed 1.
4. To increase the hand mixer speed, slide
the Speed Control forward. To decrease
the hand mixer speed, slide the Speed
Control backward.
5. When the mixing job is finished, shut
off the hand mixer by sliding the
Speed Control backward as far as
possible. Unplug the hand mixer before
removing the accessories.
6
C
5