Using The Appliance - Philips HB822 Manual Del Usuario

2
1
C
5 Turn the lamp unit a quarter turn.
C
6 Place the tanning appliance beside a bed as indicate in the
figure.
The distance between the UV filter and the surface on which you are
lying down (e.g. the bed), must be 85 cm.
C
7 Loosen the height adjustment lock by sliding the collar down
the stand. Pull the lamp unit up at the same time to a height of
85 cm above the bed.
Let go of the collar to lock the lamp unit into position.
You can check the distance between the lamp unit and the bed by
pulling out the measuring tape.
The measuring tape will automatically rewind if you move the red
tab sideways.
The appliance is now ready for use.

Using the appliance

1 Fully unwind the mains cord.
2 Put the plug in the wall socket.
Consult the table in these directions for use and your own notes.
B
Put on the protective goggles provided.
B
C
3 Set the timer to the appropriate time for the tanning session.
4 Lie down under the lamp unit.
The timer will automatically switch the tanning appliance off when the
set tanning time has elapsed.
The timer can be set to a maximum tanning time of 60 minutes.
If you want to tan both sides of your body in one session, reset the
timer just before the set time for tanning one side has elapsed. In this
way you can avoid the waiting time of at least 3 minutes, which is
necessary
ENGLISH
11