After The Tanning Session - Philips HB822 Manual Del Usuario

ENGLISH
12
2
1
to let the tanning lamps cool down. It is only possible to switch the
tanning lamps on again after they have cooled down.

After the tanning session

C
1 Keep track of the number of sessions you have had by means
of the memory knobs.The appliance has two memory knobs:
one for each person.
Cleaning
1 Always unplug the appliance and let it cool down before you
start cleaning it.
2 Clean the outside of the appliance with a damp cloth.
Do not let any water run into the appliance.
3 Do not use any scouring agents or scouring pads.
Never use abrasive liquids like scourers, petrol or acetone to clean the
appliance.
You can clean the outside of the UV filter with a soft cloth
sprinkled with some methylated spirits.
Storing
1 Let the appliance cool down for 15 minutes before you put it
in transport position and store it.
In the meantime, you can wind up the cord and put it in the base of
the appliance.
2 Make sure the cord is stored properly and does not get stuck
between the hinging parts of the appliance when you put the
appliance in transport position.
C
3 Loosen the height adjustment lock by sliding the collar down
the stand. Push the stand down at the same time.Then let go of
the collar.