Troubleshooting - Silverline 955936 Manual Del Usario

GB

Troubleshooting

Problem
Tool does not start when On/Off
Switch (4) is operated
Blade (1) not cutting correctly
Hook & Loop Sanding Sheets come
loose from Hook & Loop Backing Pad
during use
Unknown mechanical noise
Burning smell or other abnormal
operation
8
Possible cause
No power
Defective On/Off Switch or tool fault
Speed setting too low
Material may not be suitable for the blade installed
Material not suitable for tool
Blade may be worn
Speed set too high
Too much downward pressure during use
Hook & loop surface of backing pad worn out
Accessory not securely fitted
Tool fault
Tool fault
Solution
Check power supply
Return the tool to an authorised Silverline service centre for repair
Increase speed
Change blade
For some materials, including hardened metals, compatible blades are unavailable.
Revert to alternative methods of cutting
Replace blade
Reduce speed
Reduce hand pressure
Replace Hook & Loop Backing Pad
Check blade or other accessory is securely tightened
Stop using the tool and return it to an authorised Silverline service centre for repair
Switch the tool off and disconnect from power supply immediately. Return it to an
authorised Silverline service centre for repair