Troubleshooting - Silverline DIY 430787 Instrucciones Originales

GB

Troubleshooting

Problem
Tool does not start when switch is in
ON position
Blade not cutting correctly
Sanding sheets come loose from
sanding pad during use
Unknown mechanical noise
Burning smell or other abnormal
operation
8
Possible cause
No power
Defective switch or tool fault
Speed setting too low
Material may not be suitable for the blade installed
Material not suitable for tool
Blade may be worn
Speed set too high
Too much downward pressure during use
Hook and loop surface of sanding pad worn out
Accessory not securely fitted
Tool fault
Tool fault
Solution
Check power supply
Return the tool to an authorised Silverline service centre for repair
Increase speed
Change blade
For some materials, including hardened metals, compatible blades are unavailable.
Revert to alternative methods of cutting
Replace blade
Reduce speed
Reduce hand pressure
Replace sanding pad
Check blade or other accessory is securely tightened
Stop using the tool and return it to an authorised Silverline service centre for repair
Switch the tool OFF and disconnect from power supply immediately. Return it to an
authorised Silverline service centre for repair