Connecting The Gas Supply - Kenmore 796.8158 Manual De Uso Y Cuidado

CONNECTING GAS DRYERS (continued)
,A WARNING: To reduce the r .koffire,
electric shc.ck, or injury to persons when using this
appliance, follow basic precautions, including
the following:
* installation and service must be performed by a
qualified installer, service agency, or the gas supplier.
Failure to do so can result in fire, explosion, or death.
* Use only a new stainless steel flexibie connector and
a new AGA-cerfiNed connector. Failure to do so can
result in_re, explosion, or death.
"A gas shutoff valve must be installed within 6 ft.
(1.8 m) of the dryer. Failure to do so can result in fire,
explosion_ or death.
* The dryer is configured for natural gas when
shipped from the factory. Make sure fhaf the drier
is equipped with the correct burner nozzle for the
type of gas being used (natural gas or propane gas).
Failure to do so can result in fire, explosion, or death.
Connecting the Gas Supply
NOTE: This dryer is configured from the factory set for
natural gas (NG). If dryer is to be used with propane
(LP} gas, it must be converted by a qualified
service technician.
* If necessary, the correct nozzle (for the LP nozzle kit,
order part number 383EEL3002D) should be installed
by a qualified technician and the change should be
noted an the dryer. Failure to do so can result in fire,
explosion, or death.
. All connections must be in accordance with local
codes and regulations. Faiture to do so can result in
fire, explosion, or death.
"Gas dryers MUST exhaust to the outdoors. Failure to do
so can result in fire, explosion, or death.
OMake sure that the gas supply to the laundry room is
turned OFF and the dryer is unpJugged. Confirm that
the type of gas available in your laundry room is
appropriate for the dryer.
Remove the shipping cap from the gas fitting at the
back of the dryer. Be careful not to damage the
threads of the gas connector when removing the
shipping cap.
_Connect the dryer to your laundry room's gas supply
using a new flexible stainless steel connector with a 3/s
inches NPT fitting.
NOTE: DO NOT use old connectors.
OSecurely tighten all connections between the dryer
and your laundry room's gas supply.
_Turn on the gas supply.
_Check all pipe connections (both internal and external)
for gas leaks with a noncorrosive leak-detection fluid.
Proceed to Venting the Dryer.
3/8in. NPT Gas
Connection
AGA!CSA-Cerfifled
Stainless Steel Fiexibie
Connector
--Y8 in. NPT Pipe PRug
Gas Supply
Shutoff Valve
High-Altitude installations
The BTU rating of this dryer is AGA-certified for
elevations below 10,000 feet.
If your gas dryer is being installed at an elevation
above 10,000 feet, it must be derated by a qualified
technician or gas supplier.
11