Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
7.9
RECOMMENDED SPARE PARTS
You'll always be able to use your machine as ef-
ficiently as possible by maintaining a stock of the
most common consumable materials and by sche-
duling routine and extraordinary maintenance.
Contact your dealer for a list of these spare parts.
8. OPERATING CHECKS
8.1
THE MACHINE DOESN'T WORK
The key isn't inserted or correctly turned.
Insert and turn the key to position ON.
The battery connector is disconnected or poorly
attached to the main wiring connector.
Firmly connect the two connectors.
The machine is charging.
Complete the charging operation.
The batteries are discharged.
Charge the batteries.
8.2
THE MACHINE DOESN'T MOVE
The traction lever is in neutral position.
Select a traction direction by pulling or pushing
the traction lever.
The floor slope is too high.
Push manually the machine to the upper floor
level.
The thermal protection of the traction motor
is tripped.
Stop the machine and rest it for 5 minutes, the
push the thermal breaker button.
The batteries are discharged.
Charge the batteries.
8.3
THE BRUSH DON'T ROTATE
The brush motor switch is not selected.
Press the button to activate the brushes.
The brush motor thermal breaker tripped; the
motor overheated.
Troubleshoot the cause (cords or similar items
that impede movement, surface too rough, etc.)
and press the reset breaker (the first from the top).
The transmission belt is broken.
Replace it.
The motor relay or the brush motor is broken.
Replace it.
8.4
NOT ENOUGH OR TOO MUCH DE-
TERGENT
The detergent solution tank is empty.
Fill the detergent solution tank after having
emptied the recovery tank.
The flow adjustment lever is closed or almost
closed.
Adjust/increase the detergent solution outlet
flow as required.
The detergent feed conduit is clogged in some
point.
Clean out the conduit by removing the dirt.
8.5
NO SUCTION
The suction hose is not connected to the squee-
gee.
Connect it correctly.
The suction hose or the squeegee conduit are
clogged.
Clean out and remove any obstructions from the
conduits.
The suction motor is turned off.
Activate it.
The recovery tank is full.
Empty it.
The suction motor is not receiving electric power
or is burned.
Check the connections and, for the latter case,
replace the motor.
8.6
INSUFFICIENT SUCTION
The recovery tank drain hose plug is not per-
fectly closed.
Close it correctly.
The suction hose, the squeegee conduit or the
inspection compartment is clogged.
Clean out and remove any obstructions from the
conduits.
8.7
THE BRUSH MOTOR OR THE SUC-
TION MOTOR DOESN'T STOP
Stop the machine, cutting off the main power
supply and disconnecting the main battery connec-
tor, and contact the technical service centre.
8.8
THE SQUEEGEE DOESN'T CLEAN OR
DRY EFFICIENTLY
The squeegee blades are worn or are dragging
solid dirt.
Replace or clean them.
The squeegee adjustment is not correct; the
advancement must be exactly perpendicular to the
running direction.
Adjust the squeegee.
The suction hose or the squeegee conduit are
clogged.
Clean out and remove any obstructions from the
conduits.
8.9
THE BATTERY CHARGER DOESN'T
WORK
The battery charge doesn't start .
Check that the battery charger is connected to
the battery. Consult the battery charger manual.
8.10
THE BATTERIES DO NOT CHARGE
OR DO NOT HOLD A CHARGE
At the end of the charging process, the battery
is not correctly charged (see the battery manufac-
turer's instruction-maintenance manual)
Check the battery charger error message and
check the data indicated on the display (see the
battery charger's instruction manual).
The batteries are new and do not generate
36
Publicidad
Capítulos
Tabla de contenido
