Braun Multiquick 7 J 700 Manual De Usuario página 9

Drip stop feature
When the juice spout (10a) is in a tilted position it
functions as a drip stop and collects the dripping
juice:
Turn the appliance off, wait for a few seconds until
the juice only drips from the appliance. Then push
the spout (10a) to the tilted position (fig. g).
Disassembling
1. Switch off the appliance by turning the switch (2)
to position « O » and unplug it (fig. h).
Model J700/J500: Put juice spout (10a) in upright
position to allow remaining juice to drain off.
2. Remove the pusher (9). Release the clamps to
unlock the lid (fig. h). Remove the lid.
3. Slide rests of pulp from juice collector into the
pulp container.
4. Remove the juice collector (5) together with the
filter (6). Take the filter out of the juice collector
(fig. i).
5. Remove the pulp container (4) by pulling (fig. i).
6. Remove the juice spout (10a/10b) by pressing
on both sides with thumb and forefinger at the
check marks (fig. j).
Cleaning
• Always remove the plug from the socket first!
• Disassemble the appliance as described in
«Disassembling».
• Important: Before dishwashing, pre-clean the
filter and other parts with the brush and warm
water to roughly remove the pulp.
• All detachable parts as well as the juice jug with
lid and foam separator can be washed in a
dishwasher or using warm water and normal
dishwashing liquids (without abrasive/acidic
substances). The plastic parts may discolour
when processing food with a high pigment
content (e. g. carrots): Use vegetable oil to
pre-clean before using the dishwasher.
• Parts must not be placed uptight in the dish-
washer to avoid deformation.
• Clean the motor part (1) with a damp cloth only
– never immerse it in water.
Subject to change without notice.
Please do not dispose of the product in the
household waste at the end of its useful life.
Disposal can take place at a Braun Service
Centre or at appropriate collection points
provided in your country.
10
2261001IBR_Juicer_MN_S6-68.indd 10 2261001IBR_Juicer_MN_S6-68.indd 10
(only model J700/J500)
Trouble-Shooting
Problem Possible reason
Appliance does not Clamps are not securely
work locked
Lid/filter/juice collector are
not assembled correctly
Juice splashes out of Drip stop can only collect
the spout while drip small amount of juice.
stop is activated Only activate drip stop,
when juice drips from the
appliance.
14.08.13 15:59 14.08.13 15:59