Important - Bostitch BRN175 Manual De Operación Y De Mantenimiento

the contact trip or trigger activated.
Personal injury may result.
1. Read all Safety Warnings before
using tool.
2. Connect the air supply to the tool.
3. Lift the canister door latch (E) to
open the nail guide door (H).
4. Rotate the canister door (I) open.
5. Adjust the nail platform (J) to
properly accommodate the nail
length being used. Pull the nail platform (J) up or down for desired nail.
Fig. 3
Fig. 5
6. Place the coil on the nail platform (J). NOTE: Observe fastener icon (K) Fig. 4.
Insert fasteners (L) with points down.
IMPORTANT: Fasteners must point in the same direction as they will be driven.
7. Uncoil enough nails [approximately 3" (76 mm)] to reach the nose of the tool.
8. Insert the first nail into the nose and the second nail (M) between the two rails
of the feed pawl as shown in Fig. 5.
BRN175_9R209323_MAN_kf V2_multi.indd 7
Never load nails with
Platform Position
lowest position 1-1/2" (38 mm) - 1 3/4" (44.5mm)
center position
upper position
J
M
Fig. 2
E
H
Nail Length
1-1/4" (32 mm)
3/4" (19 mm) - 1" (25 mm)
Fig. 4
K
Fig. 6
E
7 - ENG
I
L
H
1/28/15 7:41 AM