Important - SSS Siedle VNG 602 Serie Informacion De Producto

English
Application
Video line rectifier in a switch panel
housing for central supply of video
door intercom systems.
It can additionally be used as a uni-
versal voltage supply.
Intended application
This device may only be installed and
used to supply the Siedle In-Home
bus, as described in this document
and in the system manual. Any other
use is prohibited and not in accord-
ance with the intended use, the
manufacturer accepts no liability for
the consequences of such use.
Electrical voltage
• Mounting, installation and ser-
vicing work on electrical devices may
only be performed by a suitably
qualified electrician.
Failure to observe this regulation
could result in the risk of serious
damage to health or fatal injury due
to electric shocks.
• For surface mounting, ensure that
"protection against direct contact"
with active parts is provided. For
details, consult VDE 0100/DIN 57100
part 410.
• Observe DIN EN 60065!
In a building installation, an all-
pole mains switch with a contact
opening of at least 3 mm must be
provided. The device must not be
exposed to water drops or sprayed
water! Sufficient ventilation must be
ensured. Pay particular attention to
ensure that ventilation slots are not
covered.
• When using stranded cores as
cable material, these must be fitted
with wire end ferrules without fail.
4
USA version
The line rectifier in the 120 V version
may only be operated in a closed
switch cabinet. Covering solely with
the ZAP 10-0 is not sufficient. The
120 V variant may only be used
in conjunction with ITE devices.
(Information Technology Equipment)
Scope of supply
• line rectifier for top hat rail
mounting
• this product information
Mounting in distribution cabinet
1 Clip the line rectifier onto the top
hat rail.
Surface mounting
(only 230 V version)
2 Surface mounting only using
accessory ZAP 10-0. Clip the pro-
vided latches onto the back of the
line rectifier. Mount the device on
the wall.
Installation and commissioning
Installation and commissioning are
described in the relevant system
manual.

Important!

The VNG 602-... has a thermal fuse
on the secondary side. After a short
circuit or overload, check the primary
fuse and disconnect the device from
the mains for 1 minute.
Terminal assignment
L1, N Power connection
+M, –M Supply voltage 30 V DC
LED display
LED On Ready for service
LED Off Fuse is defective
Specifications
VNG 602-02:
Operating voltage: 230 V AC,
+/-10 %, 50/60 Hz
Operating current: 250 mA
Output voltage: 30 V DC
Output current: 1.1 A
Fusing: Si 1 T 315 mA,
secondary side thermal fuse
Protection system: IP 20
Ambient temperature:
0 °C to +40 °C
Horizontal pitch (HP): 10
Dimensions (mm) W x H x D:
180 x 89 x 60
Specifications
VNG 602-12:
Operating voltage: 120 V AC,
+/–10 %, 50/60 Hz
Operating current: 400 mA
Fusing: Si 1 T 630 mA,
secondary side thermal fuse
For further technical specifications
see above