Q Acoustics 3000i Serie Manual Del Usuario página 22

Preparation
Lift the speakers from the cartons by holding the cabinets. Do not touch
the driver units or use the protective bags to lift them. The 3050i and
3060S are heavy - get assistance to lift them if necessary.
Foam Bung
The 3000i series speakers are rear ported and
designed to work best with some space behind
them i.e. 200mm or so away from a wall. If you
position your speakers close to a wall / corner then
the foam bungs should be inserted into the rear
ports or there could be too much bass.
Ensure the bungs are fitted snugly into the port
without inserting them too far. You will find the
level of bass is reduced but definition and bass
extension is increased. Experiment to see what
you prefer and try making small changes to the
position of the speaker to optimise the final result.
Spikes are sharp. Exercise care!
Never place a spiked loudspeaker where it can cause damage!
Always move your loudspeakers by lifting them - never drag them!
3050i - Attach the rear stabiliser
Thread the spikes fitted with locking nuts half way into the base and return the loudspeaker to the
upright position. (If you have a wood or stone floor push a spike protector over each spike before
turning the speaker upright) When the speaker is the right way up, insert the Allen key into each rear
spike from the top and adjust all the spikes in and out until the loudspeaker is level and stable.
Use screws provided to secure feet as shown.
6