Página 1
PASADENA BUTTRESS ALCOVE SHOWER INSTALLATION MANUAL | MANUEL D’INSTALLATION | MANUAL DE INSTALACIÓN DOOR PANEL & BUTTRESS INLINE PANEL PANNEAU DE PORTE & PANNEAU INLINE MI-HAUTEUR PANEL DE PUERTA & PANEL INLINE DE MEDIA ALTURA Questions, problems, need help? Call our customer service department at 1-866-839-2888, 8 a.m.
Página 2
SHOWER DIMENSIONS DIMENSIONS DE LA DOUCHE DIMENSIONES DE LA DUCHA Measurements Rule of Measure Mesures Règle de la mesure Medidas Regla de medida Shower width Distance from the leftmost edge of the shower to the rightmost edge Largeur de la douche Distance de l’extremité...
Página 3
SHOWER DIMENSIONS DIMENSIONS DE LA DOUCHE DIMENSIONES DE LA DUCHA DIM W DIM D DIM DP DIM UI DIM O Measures: inch [millimeter] Mesures: pouce [millimètre] Medidas: pulgadas [milímetros] P. 3...
Página 4
INSTALLATION STRUCTURE OVERVIEW VUE D’ENSEMBLE DE LA STRUCTURE D’INSTALLATION VISIÓN GENERAL DE LA ESTRUCTURA DE INSTALACIÓN 1. Before you start the installation of your product consult the illustration 1 below showing a side-view of the completed installation. 2. Illustration 2 shows the recommended wall structure and measurements for the product installation. NOTE: Customer must follow and comply with the local and national building and plumbing codes.
Página 5
PACKAGE CONTENT CONTENU DE L’EMBALLAGE CONTENIDO DEL PAQUETE P. 5...
Página 6
PACKAGE CONTENT CONTENU DE L’EMBALLAGE CONTENIDO DEL PAQUETE P. 6...
Página 7
PART LIST LISTE DES PIÈCES LISTA DE PIEZAS PART # DESCRIPTION QUANTITY CODE # DE PIÈCE DESCRIPTION QUANTITÉ CODE PARTE # DESCRIPCIÓN CANTIDAD CÓDIO Oil rubbed bronze / Bronze huilé brossé / Bronce aceitado: Wall track (Door Panel) Chrome / Chrome / Cromo: Glissière (Panneau de Porte) Satin Nickel / Nickel satiné...
Página 8
PART LIST LISTE DES PIÈCES LISTA DE PIEZAS PART # DESCRIPTION QUANTITY CODE # DE PIÈCE DESCRIPTION QUANTITÉ CODE PARTE # DESCRIPCIÓN CANTIDAD CÓDIO Oil rubbed bronze / Bronze huilé brossé / Bronce aceitado: Wall track gasket Chrome / Chrome / Cromo: Joint d’étanchéité...
Página 9
SUPPLIED HARDWARE LIST QUINCAILLERIE FOURNIE CONTENIDO DE HARDWARE Wall Anchor Screw Screw Fitting Ancrage mural Raccord Capuchon Tarugo Tornillo Tornillo Accesorio Capuchón ø8x30mm ST5x30mm ST4x12mm Bolt Screw Screw Allen key Boulon Clé Allen Perno Tornillo Tornillo Llave Allen M5x20mm ST5x40mm ST4x20mm 2.5mm &...
Página 10
REVERSIBILITY RÉVERSIBILITÉ REVERSIBILIDAD This instruction is drawn up for a door opening from right to left (see illustration A). For an installation for a door opening from left to right (see illustration B), use the same instructions, but switch around the panels: mirror effect. Utilisez ces instructions pour une ouverture de la porte de droite à...
Página 11
SAFETY INFORMATION INFORMATION SUR LA SÉCURITÉ INFORMACIÓN DE SEGURIDAD CAUTION Please carefully read the following important safety information before handling or installing this shower. There is a risk of serious injury while handling this product. To minimize these risks, please note: •...
Página 12
SAFETY NOTICE AVIS DE SÉCURITÉ AVISOS DE SEGURIDAD NOTICE Any modification or alteration from what is specified in this instruction manual will void any and all warranty on this product. The distributor is not responsible for any damage to the unit or personal property caused by improper installation. If you disregard instructional warnings, you will void your warranty and possibly deal with water damage.
Página 13
WALL TRACK INSTALLATION INSTALLATION DE LA GLISSIÈRE INSTALACIÓN DEL RIEL DE PARED 1.1-1.2. Position the wall track (A) as illustrated. Level the track (A) and mark the track holes positions. 1.3. Remove the track and drill pilot holes in the marked locations with a ø5/16” (8mm) drill bit. 1.4.
Página 14
WALL TRACK INSTALLATION INSTALLATION DE LA GLISSIÈRE INSTALACIÓN DEL RIEL DE PARED 2.1. Insert the Gasket Stopper (J) into the bottom of the wall track (I). 2.2-2.3. Position the wall track (I) as illustrated. Level the track (I) and mark the track holes positions. 2.4.
Página 15
SHOWER DOOR INSTALLATION INSTALLATION DE LA PORTE DE DOUCHE INSTALACION DE LA PUERTA DE DUCHA 3.1. Apply a clear silicone to the pivot profile (B). 3.2-3.3. Insert the door panel (C) into the pivot profile (B), making sure the top edge of the door panel (C) is flush to the top of the pivot profile (B), as well as the entire side of the panel being snug in the pivot profile.
Página 16
SHOWER DOOR INSTALLATION INSTALLATION DE LA PORTE DE DOUCHE INSTALACION DE LA PUERTA DE DUCHA 4.1. Insert the door bottom seal strip (E) into the door panel (C). 4.2. Insert the pivot profile (B) into the wall track (A). 4.3-4.4. Cut the side panels bottom seal strip (M). Install the seal strip (M) at the bottom of the inline panel (L). 4.1.
Página 17
INLINE PANEL INSTALLATION INSTALLATION DU PANNEAU INLINE INSTALACIÓN DEL PANEL INLINE 5.1. Insert the inline panel (L) into the wall track (I). 5.2-5.3.Insert the wall track gasket (K) between the wall track (I) and the inline panel (L) from the top towards the bottom. At this step, do not insert the full lenght, only enough to hold the panel in place.
Página 18
INLINE PANEL INSTALLATION INSTALLATION DU PANNEAU INLINE INSTALACIÓN DEL PANEL INLINE 6.1. Place the magnetic strips (S) onto the buttress, cut the surplus part with a cutter. 6.2.-6.3. Insert the magnetic seal strips (F & O) onto the door panel (C) and the inline panel (S). Adjust the door panel (C) and the inline panel (S) to yield a tight door seal.
Página 19
INLINE PANEL INSTALLATION INSTALLATION DU PANNEAU INLINE INSTALACIÓN DEL PANEL INLINE 7.1. Place and adjust the magnetic strips (S) on the buttress to yield a tight door seal, mark the position of it on the buttress. 7.2. Remove the protective film from the magnetic strips (S), apply some silicone onto the buttress, install the magnetic strips (S) onto the marked position on the buttress.
Página 20
CLAMP INSTALLATION INSTALLATION DES PINCES INSTALACION DE LA ABRAZADERA 8.1. Disassemble the clamps (N). 8.2. Place the clamps (N) into the inline panel (L), mark the hole’s place. Remove the clamp and make a hole in the base using ø1/8” (3mm) drill bit. 8.3.
Página 21
HANDLE INSTALLATION INSTALLATION DE LA POIGNÉE INSTALACIÓN DE LA MANIJA 9.1-9.2. Secure the door panel (C) by drilling guide holes through the wall track (A) and screwing it in place using fittings (DD), screws (CC) and caps (EE). Measure approcimately 3” 15/16 (100mm) from the top and bottom, and at the center height of the wall track (A). 9.3.
Página 22
SEALING SCELLAGE SELLADO Ensure that the door closes tightly and opens smoothly. Ensure that there is a firm connection between the fixed panel(s) and the support bar. Apply a clear silicone water sealant around the outside perimeter of any fixed shower components. Allow 24 hours for silicone to dry. Improper application of silicone sealant may cause your shower to leak.
NEXT STEP MAY REQUIRE TO TRIM THE SUPPORT ARM If the glass panel width “D” is smaller than 19 11/16” (500mm), you will have to trim it down. Below calculation is for reference only: Ensure you made all the proper measurements before you cut the bar. 1.
Página 24
SUPPORT ARM INSTALLATION INSTALLATION DE LA BARRE DE SOUTIEN INSTALACIÓN DE LA BARRA DE APOYO 11.1. Mount the anchor (P) and the support arm brackets (R) onto the support bar (Q). 11.2. Fix the anchor (P) to the support bar (Q) with the bolts (FF). 11.3.
Página 25
SUPPORT ARM INSTALLATION INSTALLATION DE LA BARRE DE SOUTIEN INSTALACIÓN DE LA BARRA DE APOYO 12.1. Completely remove the support arm (Q). 12.2-12.3. Drill a hole on the center marks with a ø5/16” (8mm) drill bit . If there are no studs located behind the support arm anchor (P), then insert the wall anchors (AA) using a rubber mallet until the wall anchors are flush with the wall.
Página 26
SUPPORT ARM INSTALLATION INSTALLATION DE LA BARRE DE SOUTIEN INSTALACIÓN DE LA BARRA DE APOYO 13.1. The anchor (P) allows you to adjust the angle between the anchor (P) and the support arm (Q). Loose or tighten the bolt of the anchor (P) to make the anchors (P) attach to the wall correctly.
Página 27
SUPPORT ARM INSTALLATION INSTALLATION DU BRAS DE SUPPORT INSTALACIÓN DE LA BARRA DE APOYO 14.1. Loose the outer side screw (GG) enough to allow for some movement. 14.2. Loose or tighten the bolt of the anchor (P) to adjust the angle of the panel. 14.3-14.5.
Página 28
MAINTENANCE AND CARE ENTRETIEN ET MAINTENANCE MANTENIMIENTO Y CUIDADO For the daily maintenance, use a wet cloth and a soft liquid cleaner on all glass and acrylic surfaces. Doing so will prevent soap or hard water buildups that can etch the glass or acrylic surface over time if left to dry. Never use abrasive cleaners containing some acetone, chlorine or strong bleach, scrapers, metallic brushes, nor other objects or the products which can graze or tarnish surfaces.
Página 29
LIMITED Product Warranty The DISTRIBUTOR is a distributor of the following Products: • Shower Doors (warranty period 5 years). • Acrylic Surfaces (warranty period 5 years against blistering, cracking or chipping in the acrylic surface). • Acrylic Shell Structure (warranty period 5 years against loss of water through fiberglass laminate of the acrylic body). •...
Página 30
ANNEX GUIDELINES UTILISATION DE L’ANNEXE USO DEL ANEXO HOW TO USE THE ANNEX TO FIND ADEQUATE DIMENSIONS The dimensions provided the tables of this ANNEX will vary based on the exact configuration of the shower kit you purchased. Refer to the dimensions fitting for your shower configuration.
Página 31
ANNEX DIMENSIONS DRAWINGS DESSINS DE DIMENSIONS POUR ANNEXE DIBUJOS DIMENSIONALES DEL ANEXO DIM DP DIM UI DIM O DIM W DIM D DIM B Finished Wall or Tiles Stud Mur fini ou Tuiles Drywall Montant Pared o azulejos Placoplâtre Soportes Paneles de yeso DIM A 1/2”...