Install The Connectamajig™ To The Remote - SRAM ROCK SHOX X Loc Full Sprint Manual Del Usuario

I n s t a l l t h e C o n n e c t a m a j i g ™ t o t h e R e m o t e
1. Inspect and clean the Connectamajig hose fitting threads and ball check valve.
2. Push the hose fitting into the Connectamajig sleeve and turn the sleeve clockwise to
thread the assembly together.
3. Continue to turn the knurled sleeve until it stops. Use a 6 mm open end wrench to hold
the hose fitting, then use a torque wrench with a 9 mm crowfoot socket to tighten the
assembly to 1.2-2.8 N∙m (11-24 in-lb).
10
Install the ConneCtamajIg™ to the Remote
2
9
6
3