Install The Remote To The Handlebar - SRAM ROCK SHOX X Loc Full Sprint Manual Del Usuario

I n s t a l l t h e R e m o t e t o t h e H a n d l e b a r
1. Position the clamp block or XLoc™ compatible brake lever against the handlebar. Close
the remote clamp around the handlebar and clamp block/brake lever.
2. Install the remote clamp bolt and use a T25 TORX® wrench to tighten it just enough to
prevent the remote from rotating freely.
3. Rotate the remote on the handlebar to the desired position.
2
T25

Install the Remote to the handlebaR

9