I n s t a l l t h e H o s e t o t h e R e a r S h o c k
1.
Push the hose into the shock banjo fitting until it stops.
2.
Slide the compression fitting and compression nut up to the banjo fitting. Turn the
compression fitting clockwise to thread it into banjo fitting until it stops.
3.
While continuing to push the hose into the banjo fitting, use a torque wrench with an 8 mm
crowfoot socket to tighten the compression nut to 5 N∙m (44 in-lb).
install the crowfoot onto the torque wrench at a 90° angle to the handle to ensure an
accurate torque reading�
4.
Slide the hose boot onto the banjo fitting.
12
Install the hose to the ReaR shock
8
3
5 N·m
(44 in-lb)
4