Bleed Preparation - SRAM ROCK SHOX X Loc Full Sprint Manual Del Usuario

B l e e d P r e p a r a t i o n
1. Check that the remote actuator is in the unlocked position.
2. Turn the gate adjuster on the remote toward the "+" sign until it stops.
3. Rotate the remote on the handlebar until the bleed screw is at the highest point.
4. Fill one syringe from the RockShox® Reverb™ Bleed Kit 3/4 full of RockShox Reverb Hydraulic
Fluid. Fill the other syringe 1/4 full.
5. Use a T10 TORX® wrench to remove the bleed screw from the rebound adjuster on the rear
shock. Thread the 3/4 full syringe into the bleed port on the rear shock.
6. Use a T10 TORX wrench to remove the bleed screw from the remote. Thread the 1/4 full
syringe into the bleed port.
1
2
5 6

Bleed PreParation

13