BH FITNESS G152X Instrucciones De Montaje página 42

FITTING THE ABDOMINAL
ARMS.-
7.-Once the support (33) in step 6 of
these instructions has been fitted, take
hold of the
handtighten the bolts (106) onto the
support (33), Fig.11.
Next, take ther arms (36-37) and slot
them onto the tubes (34-35) in the
direction of the arrow, Fig.11, fit the
bolts and tighten securely, as well as
bolts (106) that were left handtight.
FITTING THE BUTTERFLY ARM
SUPPORT.-
8.- Fit the butterfly arm support (18)
into the top support (1), Fig.12. Insert
bolt (115), along with washer (121)
and nut (126), and tighten securely. Fit
the nut cap (73).
FITTING THE ARM LIMIT PLATE.-
9.-Take the nuts, washers and bolts
off the arm rotation support Fig.12.
Next, fit the plate (19) with the logo
facing outward and refit the bolts,
washers and nut. Tighten the bolts
securely.
FITTING THE TOP FOAM COVERS.-
10.-Take the foam covers (93) and fit
them onto the two BUTTERFLY bars,
as shown in Fig.12.
Now take the handle (26), remove the
bolt and the washer Fig.12 and screw it
on to the arms (20) right and (21) left.
FITTING THE SEAT STRUCTURE.-
11.- Take the knob from the seat
support (136). Position it on one of the
two seat height setting holes Fig.13
and secure using the knob.
Fit the seat locking pin (71).
tubes (34-35)
FITTING THE SEAT HANDGRIP.-
12.- Insert the handgrip (32) through
the lower part of the seat support,
Fig.13. Attach using bolts (108),
washers (119) and nuts (125).
and
FITTING THE SEAT.-
13.-Take the seat (88) and position it
on the seat support Fig.13.
Fit the bolts (99) with their washers
(118) and tighten securely.
FITTING THE BOTTOM FOAM
COVERS.-
14.-First take the foam covers (131)
and fit them onto the top rounded
tubes for the leg support Fig.14.
Now do the same for the bottom leg
support foam covers (94).
FITTING THE GLUTEAL
ACCESSORY.-
15.- Position the rear support (7), next
fit the cross support (8) and screw it
on to the outer seat frame (3 and 4),
Fig.15. Fit bolts (109) along with
washers (120) and nuts (125).
Now take the gluteal support (9),
Fig.16, and attach it to the supports
(7) and (8) using bolts (110), washers
(119) and nuts (125) Fig.16.
NOTE:
assembly has been completed, all of
the bolts fitted previously should be
retightened securely.
FITTING THE SEAT HANDGRIP.-
16.– Position the handgrips (16) and
(17) on the gluteal support (9), Fig.17.
Attach using bolts (110), washers
(119) and nuts (125).
42
Once this stage of the