Aigostar 8433325504366 Manual Del Usuario página 6

4. You also can start operating by pressing and hold the high speed button (turbo button), the
appliance will operate at the highest speed all the time. The speed will not change even if you
dial the speed control dial.
5. To stop the hand-held blender by releasing the low speed button or high speed button.
Instruction for chopper
Max operation duration per time cannot exceed 1 minute, and 1 minute rest time must be
maintained at two consecutive cycles.
1. Place the chopper bowl on a clean, level surface.
2. Assemble the stainless chopping blade into the chopper bowl, as shown in Fig.1.
3. Place food into the chopper bowl.
Note: remove the bone of the meat, cut small piece, then place the meat into bowl, the max
quantity of meat can't exceed 200g in every blending.
4. Attach the lid onto the chopper bowl, make sure the tuber on the inside wall of bowl aligns
with the groove of lid, then put down the lid and turn it in clockwise direction until it locks into
position. (See Fig.2) To detach the lid, turn in adverse direction.
5. Insert the motor unit into the hole of the chopper lid, and turn in clockwise direction to lock.
(See Fig.3)
6. Plug the appliance to power outlet. Then press and hold the low speed button to start
operating. At the same time you can select desired speed setting by dialing the speed control
dial, there are five settings: 1, 2, 3, 4, 5 (from low speed to high speed).
7. You also can start operating by pressing and hold the high speed button (turbo button), the
appliance will operate at the highest speed all the time. The speed will not change even if you
dial the speed control dial.
8. To stop the appliance by releasing the low speed button or high speed button of the motor
unit.
9. After finishing chopping, unplug the power outlet firstly, then remove the motor unit from the
chopper lid by turning it in anti-clockwise.
10. Open the chopper lid by turning it in anti-clockwise and remove the chopped food.
Caution:
-To reduce the risk of injury, never place cutting blade on base without first putting bowl
properly in place.
-Be sure chopper lid is securely locked in place before operating appliance.
-During operating or after chopping, for safety, you shall disassemble the motor unit from the
chopper lid firstly, then remove the chopper lid. Never remove the chopper lid with the motor
unit in place.