Environmental Protection - Worx LithiumDriveT WX251 Traducción De Las Instrucciones Originales

release the on/off switch, the light will go out.
MainTenance
Your power tool requires no additional lubrication
or maintenance. There is no user serviceable parts
in your power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power tool in a
dry place. Keep the motor ventilation slots clean.
Keep all working controls free of dust. If you see
some sparks flashing in the ventilation slots, this is
normal and will not damage your power tool.
10 10

enViRonMenTal pRoTecTion

Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
local authorities or retailer for recycling advice.
pluG ReplaceMenT (uK & iReland only)
If you need to replace the fitted plug then follow
the instructions below.
IMPORTANT
The wires in the mains lead are colored in
accordance with the following code:
Blue =Neutral
Brown = Live
As the colors of the wires in the mains lead of this
appliance may not correspond with the colored
markings identifying the terminals in your plug,
proceed as follows. The wire which is colored blue
must be connected to the terminal which is marked
with N. The wire which is colored brown must be
connected to the terminal which is marked with L.
warning: Never connect live or neutral wires to
the earth terminal of the plug. Only fit an approved
13ABS1363/A plug and the correct rated fuse.
Note: If a moulded plug is fitted and has to be
removed take great care in disposing of the plug
and severed cable, it must be destroyed to prevent
engaging into a socket.
Connect
Blue to N
(neutral)
Outer sleeve
firmly clamped
13 Amp fuse approved
to BS1362
Brown L (live)
Cable grip