Intended Use; Assembly And Adjustment; Environmental Protection - Worx WX252 Manual Original

OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction book carefully.

INTENDED USE

The power tool is intended for driving in and loosening screws as well as for
drilling in wood, metal and plastic.
ACTION
BEFORE OPERATION
Charging the Battery
NOTE:
1. Maximize Battery Performance Prior to initial use, the
battery must be charged 5 hours to fully utilize the battery
capacity.
2. When the battery is full charged, the light turns green.

ASSEMBLY AND ADJUSTMENT

Selecting the Proper Bit
Inserting and Removing bits
Forward/reverse/lock
WARNING: Never change the direction of rotation
when the chuck is rotating, wait until it is stopped!
Adjust the Extended Shaft Position
OPERATION
Operating the On/Off Switch
WARNING: Do not operate for long periods at low
speed because excess heat will be produced internally.
LED Light Indicator
MAINTENANCE
Your power tool requires no additional lubrication or maintenance. There is no user
serviceable parts in your power tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always store your power tool in a dry
place. Keep the motor ventilation slots clean. Keep all working controls free of dust.
If you see some sparks flashing in the ventilation slots, this is normal and will not
damage your power tool.

ENVIRONMENTAL PROTECTION

Waste electrical products must not be disposed of with household waste.
Please recycle where facilities exist. Check with your local authorities or
retailer for recycling advice.
FIGURE
See Fig. A
See Fig. B
See Fig. C
See Fig. D1, D2, D3
See Fig. E, F
See Fig. G
See Fig. G
EN
13