Beninca RR.4WBV Manual De Instrucciones página 10

MENU
Menu to type in the transmitter codes in memory.
The submenus are described hereunder:
CH1
CH2
CH3
CH4
SINC
Add
FIX
ser
key
Menu to erase previously typed in transmitter codes from memory.
The single submenus are described hereunder:
DEL code
key
The receiver memory is completely erased. All transmitter codes and relevant associations and
channel parameters are cancelled.
res
A conrmation of the operation is being asked.
Search Menu for transmitter codes stored in memory.
The single submenus are described hereunder:
find
Code
N Tx
10
The key is associated to channel 1. Press, within 5 sec, the transmitter key which is
to be associated to channel 1.
Synchronism control is activated (see Synchronism paragraph).
The key is associated to channel 2. Press, within 5 sec, the transmitter key which is
to be associated to channel 2.
Synchronism control is activated (see Synchronism paragraph).
The key is associated to channel 3. Press, within 5 sec, the transmitter key which is
to be associated to channel 3.
Synchronism control is activated (see Synchronism paragraph).
The key is associated to channel 4. Press, within 5 sec, the transmitter key which is
to be associated to channel 4.
Synchronism control is activated (see Synchronism paragraph).
The four keys of a four channel transmitter are automatically associated, each one to
the corresponding channel. (Key1:ch1, key2:ch2, key3:ch2 and key4:ch4).
Press, within 5 seconds, any key of a four channel transmitter.
Synchronism control is activated (see Synchronism paragraph).
The four keys of a four channel transmitter are automatically associated, each one to
the corresponding channel. (Key1:ch1, key2:ch2, key3:ch2 and key4:ch4).
Press, within 5 seconds, any key of a four channel transmitter.
Synchronism control is activated (see Synchronism paragraph).
Serialised remote controls are typed in.
Packages of factory serialised remote controls, i.e. transmitters with consecutive
codes. First of all press any key on the transmitter with lower serial code, then any
key on the transmitter with higher serial code. All transmitter codes which are within
these two codes will be automatically stored in memory. Associations are automati-
cally carried out (key1:ch1, key2:ch2, etc)
Synchronism control is activated (see Synchronism paragraph).
A key transmitter code is created to protect the Radio Menu functions.
The receiver is in a waiting mode: press any key on the transmitter which is to beco-
me the key transmitter.
Important note: keep the key transmitter with care. If it is lost, access to the Radio
Menu will no longer be possible and it will be necessary to replace the memory and
reprogram it in case of maintenance and changes.
The receiver is in a waiting mode, waiting for a memorized transmitter key to be
pressed.
The transmitter is erased from the receiver memory.
The key remote control is erased from memory. Access to the Radio Menu functions
is now free.
The receiver is waiting for a code. Press any key on the transmitter; if this is stored its
position in memory is displayed.
The number of transmitter codes stored in the receiver memory is displayed.
FUCTION