Beninca RR.4WBV Manual De Instrucciones página 9

6 - By using the <+> or <-> keys, select the value to be assigned to the function.
7 - Press the <PG> key, "PRG" is displayed which means the programming has been successful.
You can return to the upper menu without making changes if you press the <+> and <-> keys simultaneously
in a Function Menu.
If you press the <+> and <-> keys simultaneously when the display is switched off, the card software version
is shown. Press PG to select the desired value. OK is shown to conrm a successful programming.
If either the <+> key or the <-> key are kept pressed, the increase/reduction of numeric values is accelerated
in the Time Menu.
After 60 sec wait, the receiver exits the programming mode and the display switches off.
Each single function, which is available in the control unit, is described in the following tables.
MENU
The operating mode of channel 1 is preset.
The descriptions of the single submenus are shown hereunder:
IMp
MCH1
TG
Time
MCH2
Same operating modes preset for
MCH3
Same operating modes preset for
MCH4
Same operating modes preset for
MENU
With this function enabled, channel 1 switches only if the corresponding key is pressed for
longer than 3 seconds.
safe
This function is useful specially to control alarm installations or in cases when accidental acti-
vation is to be averted.
In order to avoid undesired access, the access to this group of functions can be protected by a key transmitter
code.
The receiver comes with free access to all functions but, if necessary, a key transmitter code can be provided
(see key function).
Once the key function is activated, the radio menu waits for any transmitter key to be pressed as access
key.
The transmitter code which is memorized as key function can be copied to obtain new key transmitters.
Only when the key code is received, the radio menu can be programmed.
PARAMETERS:
Monostable. The relay activates for 1 sec when the corresponding key is pressed;
then the relay returns to its original status.
Bistable. When the associated key in the transmitter is pressed, the relay activates. It
remains in its new status until the key is pressed again.
Timed. The relay activation time can be preset within a range of 1 to 600 seconds (10
min).
Select the desired activation time between 1 and 600 seconds, then press OK to store
the value into memory.
Note:
FUNCTION
MCH1
.
MCH1
.
MCH1
.
LOGICS:
FUNCTION
RADIO:
9