Storage And Transport - Advance B562HD Manual De Operación Y Piezas

STORAGE AND TRANSPORT

Remove material support bar from machine.
If booking table is used, remove boards and two brackets in sides of rolling stand.
Clean paste tank and rollers as previously instructed.
Close lid and lock both latches.
Legs can be folded with or without caster assembly in place.
If you want to remove them, loosen from locking screws first. If not, make sure that all four
screws are tight.
Pull out locking pin from leg brace on one end.
Lift machine at this end and fold against bottom of tank. Do the same on other end.
Put stainless steel cover on machine and wrap bungee cords around tank and cover to hold it in place.
The machine may now be stored or transported.
Fig. 10
lid latch
booking table brackets
locking pin
leg assembly
brace
locking screws
caster assembly
PAGE 11