General Instructions - Advance B562HD Manual De Operación Y Piezas

GENERAL INSTRUCTIONS

1) Before lifting machine from shipping box, remove accessory tool box, the material support bar and
the two caster assemblies packed next to the machine.
2) Lift out machine by grabbing the stand under the tank. (Two people will be easier)
3) Set machine next to the shipping box.
4) Open rolling stand:
a) Lift up one end of machine and open leg assembly (#1313), put legs on floor, lock folding
brace (#1314) with steel pin (#1309). Lift other end and repeat procedure.
5) Install caster assemblies:
a) Lift machine at one end and slip caster assembly tubes into tubes of leg assembly.
Make sure that casters extend forward towards front of machine (latch side of machine).
Repeat with other end.
b) Raise machine to insert steel pins (#1311) in caster assembly at desired height. Lock in
position by tightening black plastic head lock screws (#1308).
6) Remove stainless steel cover.
7) Unlock both quick releases (latches) on machine lid and open lid. Remove packaging material from
rollers in tank.
8) Close lid of machine and with your hand on rubber covered reverse feed roller, rotate rollers and
check that they rotate smoothly without any binding.
9) Always lay rollers down on a dropcloth when removed from the tank. Do not lean them against a
wall or table, they may get damaged if dropped.
10) We recommend removing and cleaning the rollers each night to insure long life. Adhesive can be
left in the tank overnight.
PAGE 3