Kohler STERLING 6500 Serie Guia De Instalacion página 10

Assemble, making sure
top edges are flush.
Door Panel
Bottom Seal
6. Install the Hinge to the Door Panel
NOTE: Leave a small gap on the handle side of the door for clearance from the strike jamb. The door will
not close properly without this gap.
Align the slotted holes on the hinge with the channel in the door panel. Make sure the top edge of
the hinge assembly is flush with the top of the channel.
Secure the hinge to the door panel using four of the provided #10-16 x 3/8" truss head screws.
Install the hinge jamb cap on the top of the hinge jamb where it aligns with edge of door.
1034028-2-H
Hinge Jamb
Cap
10
Door Panel
Bottom View
Hinge Jamb Cap
Hinge Jamb Cap
Hinge Assembly
#10-16 x 3/8"
Truss Head Screw
Sterling