Kohler STERLING 6500 Serie Guia De Instalacion página 8

Without Filler Jamb
Wall Jamb
3. Install the Wall Jambs and Optional Filler Jamb
Drill the Installation Holes
With a pencil, mark the location of the wall jamb on the shower wall. Measure evenly on both sides.
Place the wall jamb against the wall and check for plumb with a level. The side of the wall jamb
with the adjustment clamps attached to it should be located to the inside of the shower.
Make a pencil mark at each of the four pre-drilled holes in the wall jamb and remove the wall jamb.
NOTE: When installing on ceramic tile, use a center punch to nick the surface of the glaze. Tap the center
punch lightly with a hammer to avoid cracking the tile.
Drill each hole with a 5/16" drill bit (use a masonry bit for ceramic tile).
Install the Anchors
Push (1) the middle of anchor in and fold (2) the outside edges down.
Insert (3) an anchor in each hole.
Repeat for all the anchors.
Install the Wall Jambs
If your installation requires a filler jamb, position the filler jamb over the holes.
Secure a wall jamb in place (over the filler jamb if needed) using four provided panhead screws.
Repeat for the other wall jamb, skipping filler jamb procedures.
Remove the bottom track and thoroughly clean the shower ledge.
1034028-2-H
Drill holes.
Anchor
3
2
#8-18 x 2"
Panhead Screw
Wall Jamb
1
Filler Jamb
8
With Filler Jamb
Adjustment Clamp
Filler Jamb
Wall Jamb
Top View
Sterling