Troubleshooting; Specifications - Sony CDP-CE345 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Additional Information

Troubleshooting

If you experience any of the following difficulties while
using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.
There's no sound.
, Check that the player is connected securely.
, Make sure you operate the amplifier correctly.
, Adjust the playback level using the ANALOG
OUT LEVEL +/– buttons on the remote (CDP-
CE345 only).
The CD does not play.
, There's no CD inside the player ("no dISC"
appears). Insert a CD.
, Place the CD with the label side up on the disc
tray correctly.
, Clean the CD (see page 17).
, Moisture has condensed inside the player.
Remove the disc and leave the player turned
on for about an hour (see page 17).
, Place the CD in the correct position on the disc
tray.
The remote does not function. (CDP-CE345 only)
, Remove the obstacles in the path of the remote
and the player.
, Point the remote at the remote sensor
player.
, Replace all the batteries in the remote with new
ones if they are weak.
The player functions incorrectly.
, The microcomputer chips may be operating
incorrectly. Turn the power off, then turn it
back on to reset the player.
GB
18

Specifications

Compact disc player
Laser
Laser output
Frequency response
Dynamic range
Harmonic distortion
Output
Jack
type
ANALOG OUT
Phono
jacks
DIGITAL OUT
Optical
(OPTICAL)
output
connector
General
Power requirements
on the
Where purchased
Europe and some Asian
countries
Australia
Other countries
Power consumption
Dimensions (approx.)
(w/h/d)
Mass (approx.)
Supplied accessories
See page 4.
Design and specifications are subject to change without notice.
Semiconductor laser (λ = 780 nm)
Emission duration: continuous
Max 44.6 µW*
* This output is the value measured at
a distance of 200 mm from the
objective lens surface on the Optical
Pick-up block with 7 mm aperture.
2 Hz to 20 kHz ± 0.5 dB
More than 93 dB
Less than 0.0045 %
Maximum
Load
output
impedance
level
Over 10 kilohms
2 V
(at 50 kilohms)
Wave length: 660 nm
–18 dBm
Power requirements
220 V - 230 V
AC, 50/60 Hz
240 V AC, 50/60 Hz
110 V - 120 V or 220 V - 240 V AC,
adjustable, 50/60 Hz
11 W
430 × 110 × 398 mm
(17 × 4 3/8 × 15 3/4 in.) incl. projecting
parts
5 kg (11 lbs 1 oz.)

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Cdp-ce245

Tabla de contenido