Cleaning And Maintenance; Disposal - Powerfix Profi HG00962B Instrucciones De Utilización Y De Seguridad

Failure
Nothing is
displayed
on the LCD
display .
3
˜ Cleaning and maintenance
Clean the angle ruler before and after using it with a dry
¡ ¡
cloth; never use petrol, solvents or cleaning agents.
Do not immerse the angle ruler into water. Liquids can
¡ ¡
damage the angle ruler.
Always switch the LCD display
¡ ¡
angle ruler. This will extend the life of the battery.
Keep away from electrical current and electrically charged
¡ ¡
pens to prevent damage to the chip.
Tip: You may use the hanging hole
after use or cleaning.
˜ Disposal
The packaging is made entirely of recyclable materials, which
you may dispose of at local recycling facilities. The Green Dot
is not valid for Germany.
Observe the marking of the packaging materials for
waste separation, which are marked with
abbreviations (a) and numbers (b) with following
meaning: 1–7: plastics / 20–22: paper and
fibreboard / 80–98: composite materials.
The product and packaging materials are recyclable,
dispose of it separately for better waste treatment.
The Triman logo is valid in France only.
Cause
1. LCD display is
switched off.
2. Battery is the
wrong way round
or the battery
contact is poor.
3. The battery
voltage is lower
than 2.4 V.
Solution
1. Switch the LCD
display on by
pressing the
ON /
OFF key
2. Remove the bat-
tery and insert /
replace it in line
with the termi-
nals and the
chapter "Insert-
ing / replacing
the battery" so
that it touches all
contacts.
3. Replace the
battery in line
with the chapter
"Inserting / re-
placing the
battery".
off when not using the
3
to store the angle ruler
8
.
5
GB/MT 35