General Instructions - T&S B-0133 La Instalación Y Las Instrucciones De Mantenimiento

General Instructions

Faucet Installation:
1. Shut off water supply and drain lines.
Drill (2) two holes, approximately
1-1/4" diameter in wall where you are
installing no.1.
2. Apply Teflon tape or pipe joint
compound to water supply lines.
8"
[20cm]
3. Connect no.1 to water supply lines
by attaching no.4 (with eccentric
centers) onto threads of pipe (supplied
by others). Hand tighten no.4 against
wall. Make sure no.3 is in place. Nut
behind wall to be supplied by others.
Trim supply lines if necessary.
wall
3
2
4
water supply line
(supplied by others)
4. Tighten no.4 with a wrench.
5. Connect supply lines, turn on water
supply and check for leaks.
Pre-Rinse Installation:
1. Shut off water supply and drain
lines. Apply Teflon tape or pipe joint
compound to threads on both ends of
no.14. Screw no.14 into no.1 and hand
tighten.
2. Slide no.15 down no.14 (about
halfway) and tighten temporarily.
3. Screw no.13
down on no.14
and hand tighten,
then tighten no.13
with a wrench, which
will also tighten no.14.
Make sure to align no.15 over center of
sink, directly in front of no.14 while
tightening.
Note: If new no.12 is being installed
on no.11, make sure it is installed in
the upright position.
4. Adjust position
of no.15 so that
no.10 hangs loosely
in it without
wall
straining no.12.
5. Turn on water
supply and
check for
leaks.
nut
Caution: Turn off
water supply at base
faucet when not in use.
4
15
14
13
14
12
11
10
15