General Instructions - T&S B-0117 Instalación Y Las Instrucciones De Mantenimiento

General Instructions

Installation:
See separate installation instructions
for installation of no. 6 into deck.
1. Shut off water supply and drain
lines. Apply teflon tape or pipe joint
compound to threads on both ends of
no. 5. Screw no. 5 into no. 6 and
tighten with no. 7.
Note: Do not
adjust no.8 in
no.4. If unit is
too high, a new,
shorter no.5
pipe should be
ordered from
T&S.
2. Remove no. 7
(do not remove
grease from parts)
and place no. 3 on
top of no. 5. Slide
no. 9 up no. 5 and
tighten with a
wrench.
3. Repeat step 2 for assembly of no. 2
and no. 3. Slide no. 10 up no. 2 and
tighten with a wrench.
7
5
1
4
4. Turn on water supply and check for
8
leaks.
Optional Wall Bracket
6
Note: T&S highly recommends
installing a B-0109-01 Wall Bracket
with these Pre-Rinse Units (included
with the B-0114-01B and the B-2362
units). It must be ordered separately
3
with other models.
The B-109-01 Wall Bracket should be
installed after entire unit is assembled.
9
Fit bracket on no. 5 as high as possible.
Cut off any excess nipple as needed,
5
and mount to wall.
Nipple
3
10
2
Note: Before
tightening no.10.
Check position of
no.1. Handle
should face front
towards the
operator.
Clamp
Screws